Main technical performance parameters

　　Engine model: 25/28/32/36

　　Main drive mode: belt drive

　　Rated power: 16/19.5/24

　　Clutch form: Tensioner type

　　Rated speed: 2200

　　, Matching with pastoral management machine

　　Dimensions: 1000*2370

　　Rotary tillage efficiency per hour: 25/28/32/36

　　Structure quality: 870kg

　　16/19.5/24

　　Trenching width: 30-40cm

　　Trenching depth: 30-40cm

　　Working speed ≥0.3m/s

　　Connection method: PAGE 03

　　Matters needing attention in the use of pastoral management machine

　　1. Before using the pastoral management machine, you must carefully read the instruction manual and master the correct operation method before using it.

　　2. It is strictly forbidden to operate by children and those who do not have the ability to operate.

　　3. Before use, conduct a comprehensive inspection of the fastening parts to ensure that the fasteners are firm and reliable.

　　4. The gearbox uses SAE90 gear oil, the added amount is about 7 liters, (added at the factory), check whether the oil meets the requirements before each use (when the machine is in a horizontal position, the oil level is in the middle of the upper and lower scale lines of the oil dipstick) ***After 2 months of use, the gear oil should be replaced again, and the gear oil should be replaced every six months after use.

　　5. Lubricate the lubrication parts before each use to ensure that the lubrication parts are well lubricated.

　　6. Check whether the elasticity of the V-belt is appropriate and whether the two belts are parallel, otherwise adjust. When adjusting, first loosen the bolts of the machine shim, adjust the longitudinal and lateral positions of the engine, make the V-belt tight, make the pulley groove on the same plane, and tighten the bolts.

　　7. Check each control handle, the cable is flexible and reliable

　　8. Put the gear lever in the neutral position, the clutch is in the disengaged state, start the engine (operate strictly according to the engine manual when starting the engine), and check whether the gear lever is flexible and reliable.

　　9. The machine has a gear shift lever, which is located on the upper right side of the gearbox. It is divided into 5 gears, four forward and one reverse gear, which can be selected according to the needs of the operation. When changing gears, the clutch must be turned off to avoid personal and equipment accidents. The fourth gear is generally not used in agricultural operations to avoid accidents.

　　10. Slowly step on the clutch when preparing to shift gears to release the clutch to shift gears, check whether the gears are normal and if there is any abnormal sound, and if abnormalities are found, immediately step on the clutch to re-engage gears.

　　11. It is forbidden to step on the brake-clutch integrated lever during operation, so as to avoid semi-interlocking, burn out the clutch, fail to normal gear, and cannot be used

　　12. The handlebar of the machine is multi-directional adjustment type. The horizontal rotation is within the range of 0~360 degrees, 24 rotation positioning points are set, the vertical rotation is within 0~240, and 5 gears are set. Can be adjusted appropriately according to job requirements.

　　13. During rotary tillage, the width of rotary tillage can be adjusted by increasing or decreasing the number of blade groups as needed, and the depth of rotary tillage can be adjusted by adjusting the guide rod.